The Cap Cooler is a unit especially designed for cooling caps and closures immediately after ejection from molding.

The highly efficient cooling action of the Cap Cooler delivers caps at a temperature approximately 3°C higher than the ambient temperature. Cap Cooler produces uniform cooling of the complete cap or closure, thus assuring regular shrinkage and constant quality of the products.

Ovalization and deformation defects are therefore reduced to minimum.

Two models are available: standard model and HF model suitable for capacity higher than 65000 ÷ 80000 closures per hour (depending on the specifications of the closure).

Main Characteristics:

  • Easy to install
  • Little floor space required
  • Low energy consumption
  • Suitable and adjustable for different cap sizes
  • Easy to adjust to different outputs
  • Stainless steel for all part contact surfaces
Tecnical Data
Unit
Cap Cooler Standard Version
Cap cooler HF Version
Fan Power kW 3 4
Gearmotor Power kW 0.13 0.25
Noise Level dbA <78 <78
Colour RAL 9010 White 9010 White
Net Weight kg 225 300
Voltage Volt - Hertz 380 - 415V/3/50 Hz • 380 - 460V/3/60 Hz 380 - 415V/3/50 Hz • 380 - 460V/3/60 Hz
Dimensions (L-W-H) mm 1257 - 757 -1709 2000 - 757 - 1722
Dimensions (A-B) mm 1091 - 797 1104 - 810
Dimensions (L1) mm ~ 1803 ~ 2550

Available special versions:

  • Heat exchanger with chilled water connections for ambient temperature higher than 38°C
  • With H13 absolute filters